Questions and answers on how to convert things from one unit or system to another
Forum rules
Dear convert-me.com forum visitors,
Our forum has been available for many years. In September 2014 we decided to switch it to read-only mode. Month after month we saw less posts with questions and answers from real people and more spam posts. We were spending more and more resources cleaning the spam until there were less them 1 legitimate message per 100 spam posts. Then we decided it's time to stop.
All the posts in the forum will be available and searchable. We understand there are a lot of useful information and we aren't going to remove anything. As for the new questions, you can always ask them on
convert-me.com FaceBook pageThank you for being with us and sorry for any inconveniences this could caused.
Sun Jun 13, 2004 3:15 am
I'M A BS STUDENT AND I NEED TO FINISH A VERRY IMPORTANT PROJECT BEFORE TUESDAY 15,2004
I HAVE A SAVONIOUS ROTOR
WHO'S SHAFT IS ROTATING LET'S SAY 50 RPM
I NEED TO CONVERT RPM TO ANGULAR VELOCITY (RAD/S)
COZ IT IS ATTACHED TO A GEAR WHO'S GEAR RATION IS 1/4
WHO'S ATTACHED TO A WATER PUMP TO BE ABLE TO CALCULATE THE L/S COMING OUT OF THE PUMP
THANKS FOR ANY HELP, IT'S NOT TOO COMPLICATED PLEASE READ AGAIN!!!!!!!!!!!!!!!!!!!!!
RODOLPH
Tue Jun 15, 2004 5:37 am
rodolph wrote:I'M A BS STUDENT AND I NEED TO FINISH A VERRY IMPORTANT PROJECT BEFORE TUESDAY 15,2004
I HAVE A SAVONIOUS ROTOR
WHO'S SHAFT IS ROTATING LET'S SAY 50 RPM
I NEED TO CONVERT RPM TO ANGULAR VELOCITY (RAD/S)
COZ IT IS ATTACHED TO A GEAR WHO'S GEAR RATION IS 1/4
WHO'S ATTACHED TO A WATER PUMP TO BE ABLE TO CALCULATE THE L/S COMING OUT OF THE PUMP
THANKS FOR ANY HELP, IT'S NOT TOO COMPLICATED PLEASE READ AGAIN!!!!!!!!!!!!!!!!!!!!!
RODOLPH
Consider that there are 2(pi) radians in a circle, Pi is equal to 3.14. There are 60 seconds in a minute. Using this information, apply unit analysis to the questions and...
- Code:
50 Rev | 1 min | 2(3.14) Rad | rad
------------------------------- = 5.233 ---
min | 60 sec | 1 rev | sec
More info
Powered by phpBB © phpBB Group.
