You are welcome to suggest new categories, units and conversion calculators to be added to Convert-Me.Com
Forum rules
Dear convert-me.com forum visitors,
Our forum has been available for many years. In September 2014 we decided to switch it to read-only mode. Month after month we saw less posts with questions and answers from real people and more spam posts. We were spending more and more resources cleaning the spam until there were less them 1 legitimate message per 100 spam posts. Then we decided it's time to stop.
All the posts in the forum will be available and searchable. We understand there are a lot of useful information and we aren't going to remove anything. As for the new questions, you can always ask them on
convert-me.com FaceBook pageThank you for being with us and sorry for any inconveniences this could caused.
Tue Mar 30, 2004 2:04 am
I see you have a link to a wire gauges chart. But what about vinyl, pvc, and steel sheet gauge thickness? I've been searching high and low for these charts.
Wed Apr 07, 2004 7:43 pm
Anonymous wrote:I see you have a link to a wire gauges chart. But what about vinyl, pvc, and steel sheet gauge thickness? I've been searching high and low for these charts.
Vinyl and PVC sheeting is usually measured in mil, (or mm). For sheet steel, a guage converter (one of many, so caveat emptor!) is at
http://www.efunda.com/designstandards/gages/sheet_forward.cfm
More info
Powered by phpBB © phpBB Group.
