You are welcome to suggest new categories, units and conversion calculators to be added to Convert-Me.Com
Forum rules
Dear convert-me.com forum visitors,
Our forum has been available for many years. In September 2014 we decided to switch it to read-only mode. Month after month we saw less posts with questions and answers from real people and more spam posts. We were spending more and more resources cleaning the spam until there were less them 1 legitimate message per 100 spam posts. Then we decided it's time to stop.
All the posts in the forum will be available and searchable. We understand there are a lot of useful information and we aren't going to remove anything. As for the new questions, you can always ask them on
convert-me.com FaceBook pageThank you for being with us and sorry for any inconveniences this could caused.
Thu Apr 15, 2004 9:45 pm
Conversion from sheet metal gauge to decimal, fractional, inches & mm
Mon Mar 21, 2005 10:03 pm
Ken Magar wrote:Conversion from sheet metal gauge to decimal, fractional, inches & mm
looking for conversion of 24 guage to inches
Mon Mar 21, 2005 10:43 pm
Use the sheet steel column at this page:
http://www.engineersedge.com/gauge.htm
I googled several sources and they seem to agree on 0.239"
for US gauge. If British, probably the Birmingham or Stubbs gauge for steel, but I'm not sure of that. Browne & Sharp is used for nonferrous metal and is also the basis for American Wire gauge AWG
Wed Apr 06, 2005 1:19 am
Anonymous wrote:Ken Magar wrote:Conversion from sheet metal gauge to decimal, fractional, inches & mm
looking for conversion of 24 guage to inches
, 16 guage, 18 guage, 14 guage, 13 guage
Tue Mar 05, 2013 11:18 am
I am looking for conversion of 18 guage to inches.
rock salt suppliers
More info
Powered by phpBB © phpBB Group.
