Don't know how to calculate the area of your garden or circumference of a pond? Ask your question here.
Forum rules
Dear convert-me.com forum visitors,
Our forum has been available for many years. In September 2014 we decided to switch it to read-only mode. Month after month we saw less posts with questions and answers from real people and more spam posts. We were spending more and more resources cleaning the spam until there were less them 1 legitimate message per 100 spam posts. Then we decided it's time to stop.
All the posts in the forum will be available and searchable. We understand there are a lot of useful information and we aren't going to remove anything. As for the new questions, you can always ask them on
convert-me.com FaceBook pageThank you for being with us and sorry for any inconveniences this could caused.
Thu May 13, 2004 10:43 pm
I'm hoping someone can help me with this,
According to HES A3035 (This is an automotive specification for a peel test of a laminate on a plastic substrate)
The peel test result should be 25kgf minimum.
My test samples are 25mm. x 150mm. My question is: what is the minimum result I can get for an acceptable part? I came up with .28kg.
Thanks in advance for any help!
Fri May 14, 2004 1:47 am
Jam wrote:I'm hoping someone can help me with this,
According to HES A3035 (This is an automotive specification for a peel test of a laminate on a plastic substrate)
The peel test result should be 25kgf minimum.
My test samples are 25mm. x 150mm. My question is: what is the minimum result I can get for an acceptable part? I came up with .28kg.
Thanks in advance for any help!
Can you give some more information about the conditions of the test? I did a search for HES A3035, but was unable to find any reference to it on the web
More info
Powered by phpBB © phpBB Group.
