Try to post your problem here, there is a chance, someone clever will help you.
Forum rules
Dear convert-me.com forum visitors,
Our forum has been available for many years. In September 2014 we decided to switch it to read-only mode. Month after month we saw less posts with questions and answers from real people and more spam posts. We were spending more and more resources cleaning the spam until there were less them 1 legitimate message per 100 spam posts. Then we decided it's time to stop.
All the posts in the forum will be available and searchable. We understand there are a lot of useful information and we aren't going to remove anything. As for the new questions, you can always ask them on
convert-me.com FaceBook pageThank you for being with us and sorry for any inconveniences this could caused.
Thu Jun 12, 2008 3:44 am
what guage would 27 mm metal be equal to?
Thu Jun 12, 2008 4:36 am
It's off the Standard sheet and plate gauge scale, along with the Birmingham, Stubs or Brown and Sharpe gauges. Standard gauge only goes to 0000000, which is 1/2" plate.
27mm is slightly over 1" so 1" plate would be comparable.
More info
Powered by phpBB © phpBB Group.
